Popular articles

Same old song. Lolin designed a great board as intended for battery power and killed the whole design with one component
The popular step-down converter with MP2315 from aliexpress was replaced by a fake chip. Check your inventory to see if you have it at home too. It can damage your equipment. How to recognize it?
ATTO - the smallest Arduino compatible board
How to convert your DSLogic Basic into DSLogic Plus
Measure the CO2 with CozIR-LP sensor and ESP32

» Meteo v3 - verstatile board with ESP12E/ESP07/ESP08
» STM32duino (Arduino and STM32)
» BigClown (IoT platform)
» Build your own weather station with ESP8266
» Sensors for your weather station
» ESP32 and Arduino IDE
» Barometer WiFi ePaper 2.9
» Raspberry Pi 3B Plus
» Banana Pi M2 Berry
» Orange Pi Zero
» Helpful tools for makers
» Eagle CAD tips and tricks
» STM32 development boards to $5 (supported in Arduino IDE)
» How to begin with STM32 and why

Favourite Videos

Navigation

Share us



TAGs

 Arduino  Raspberry Pi  STM32  Nucleo  IoT  ESP8266  ESP32  Banana Pi  ATMega  AVR  MSP430  NanoPi  OrangePi

stats

RSS feeds

RSS News
RSS Articles

Atmel ultra-low power platform for IoT and wearable devicesPrint



Atmel company introduced a new ultra-low power platform for IoT and wearable devices on CES 2016.
The board contains ultra-low power SAM L21 family microcontrollers which based on ARM? Cortex? -M0+ based MCU running up to 48MHz with up to 256KB embedded Flash and 40KB SRAM. Consumption at <35?A/MHz.
Next important component is Atmel? BTLC1000 - ultra-low power Bluetooth? SMART (BLE 4.1).
The dimension of board is only 40 x 60 mm.
On the board are another components as capacitive touch interface, BHI160 - 6-axis motion sensor and BME280 environmental sensor.
Development board is compatible with Atmel Studio 7 IDE.

http://blog.atmel.com/2016/01/05/atmel-launches-ultra-low-power-platform-for-iot-and-wearable-devices/
No Comments have been Posted.

Post Comment

Please Login to Post a Comment.